Migrate from TIBCO AMX BW 5.x to TIBCO AMX BW 6.x

​Migration Queries

ActiveMatrix BusinessWorks 5.x constructs migrating to equivalent ActiveMatrix BusinessWorks 6.x constructs

Resolution

​The value Supported is used in "Migration Support" column for this category.
Note: Supported does not mean defect free.

---

TIBCO ActiveMatrix BusinessWorks 5.x constructs not migrating to TIBCO ActiveMatrix BusinessWorks 6.x due to:
​Corresponding ActiveMatrix BusinessWorks 6.x construct is available with corresponding migration support, but contains corner case limitations

The value Supported with Limitations is used in "Migration Support" column for this category.

---

Corresponding ActiveMatrix BusinessWorks 6.x construct is available, but ActiveMatrix BusinessWorks 5.x to ActiveMatrix BusinessWorks 6.x migration extension is not available and is under consideration for future releases

1. This means feature parity gap for ActiveMatrix BusinessWorks 6.x compared with ActiveMatrix BusinessWorks 5.x
2. The value BW6 Construct Under Consideration is used in "Migration Support" column for this category

---

Corresponding ActiveMatrix BusinessWorks 6.x construct is available, but ActiveMatrix BusinessWorks 5.x to ActiveMatrix BusinessWorks 6.x migration extension is not available and is under consideration for future releases

1. This means user can create such construct using ActiveMatrix BusinessWorks 6.x Design Studio, but automated migration from ActiveMatrix BusinessWorks 5.x is not yet supported.
2. After migration, you need to re-factor and/or re-create the construct using ActiveMatrix BusinessWorks 6.x Design Studio.
3. The value BW6 Migration Not Supported is used in "Migration Support" column for this category.

---

Fundamental design improvements in ActiveMatrix BusinessWorks 6.x renders automated migration not supportable

1. You can achieve better results in ActiveMatrix BusinessWorks 6.x compared to ActiveMatrix BusinessWorks 5.x, but only when the construct is created in ActiveMatrix BusinessWorks 6.x Design Studio.
2. After migration, you need to re-factor and/or re-create the construct using ActiveMatrix BusinessWorks 6.x Design Studio.
3. The value Refactor and Recreate is used in "Migration Support" column for this category.